Brake Drum to Hub Lug Bolt Stud Install Tool
NOTE: For rear hubs only that have studs 1-5/8" in length
Press out the old studs from your wheel hubs or drum to hub combinations and clean the surfaces where the hubs will contact the drums.
Place a new stud in position on the back side of the wheel hub or drum then slide the installation tool over the threaded portion of the stud. The tapered side of the tool will face outward. Use a new left or right hand threaded wheel nut and thread it onto the new wheel stud with the tapered side of the nut seating into the tapered side of the tool.
Tighten the wheel nut against the tool to pull the new stud into place. Use a criss cross pattern when installing the other studs to insure an even installation of the remaining studs into the drum or hub. An impact wrench will speed up the installation.
Fits:
46-49 CJ-2A
49-53 CJ-3A
53-64 CJ-3B
55-71 CJ-5
50-52 M38
52-66 M38A1
46-64 Truck
46-64 Station Wagon
48-51 Jeepster
Note:
This tool can be used on both 3/4" and 13/16" left or right handed wheel nuts. One left hand thread and one right hand thread wheel nut are included with the tool.
