NOS Front Outer Axle Tube Bushing with Bendix U Joints
Made in the USA
These are New Old Stock factory original front axle tube bushing that is pressed in the axle tube that is used with Bendix U joints. The bushing is made of brass and is only used with the U joint with the 5 balls.
If a Spicer or Rezeppa joint is used this bushing is removed
Once these are gone, they are gone forever.
Application:
Dana 25
2 required per vehicle.
Fits:
41-45 MB
41-45 GPW
46-49 CJ-2A
46-49 Truck
46-49 Station Wagon
Note:
Always check to see if the end of the axle tube is machined for this bushing. On later year Bendix and when the Rezeppa joints were introduced it seemed like the bushing was eliminated and the flanged spindle bushing was used. Some only have the flat thrust washer and the flanged spindle bushing.
